What if the propeller of charcoal machine equipment is worn?

The wear of screw propeller in the production process of charcoal machine equipment is a problem known to all charcoal manufacturers. In the production process of charcoal machine equipment, the wear of screw propeller is very fast. With several degrees of high temperature and pressure friction of more than 5 tons, the recrystallized material can not withstand for a long time. In fact, it is very simple to solve this problem. Firstly, raw materials should be dried so that the wear of thruster is relatively small. The grain size and impurity content of sawdust have an effect on the wear degree. And the size of the motor. Too small motor will also lead to accelerated wear and tear of the propeller. When welding propeller, high carbon steel wear-resistant welding rod is selected, and other welding rods are not recommended because of their fast wear rate. As long as the electrode is wear-resistant, the welding process is not very bad, generally no problem.

If we want to improve the service life of carbon machinery equipment, that is, the service life of accessories spiral propeller, taper sleeve and moulding barrel, the simple way is not to heat too fast. Someone directly adjusts the temperature controller to more than 300 degrees. Once opened, the temperature rises quickly and can be produced in 10 minutes, but this is very disadvantageous to the moulding barrel. However, heating softens steel and accelerates wear and tear. The method is to adjust 100 degrees first, then heating for a few minutes, then slowly heating, 30 to 40 minutes can reach the predetermined temperature, which is better for the forming cylinder. The thruster of charcoal machine equipment is an important part of mechanical pole machine, which usually affects the whole production of mechanical charcoal. It is particularly important to pay attention to the propeller of the rod-making machine. It is an important part of mechanical charcoal machine accessories. When propellers are in normal use, they should be dismantled and repaired after about 12 hours. However, some materials are different, and it may take a short time to dismantle and repair. Welding and grinding of propellers, experienced charcoal factories should have their own set of technology, which can be used as conveniently as possible, but everyone has different technology, which is the hub of fuel rod forming. Therefore, paying attention to the use and maintenance of charcoal engine equipment is the main way to reduce the wear and tear of thrusters and prolong the life of engines. Path.

The screw propeller is the key to making rods for charcoal machine equipment, and it is also a vulnerable part for users'headache. Jinhe Machinery suggests that users should pay attention to the wear degree of the screw propeller and repair the wear of the screw propeller in order to prolong its service life and improve the production efficiency of the charcoal machine.