Investors need to know the accessories of charcoal machine equipment.

Many investors have chosen the whole industry of charcoal machinery and equipment, but many people do not know what the parts of charcoal machinery and equipment are. Now, let's popularize them.

1, screw thruster: screw propeller on the bar making machine parts. It is a key component in the manufacture of rod making machines, and its raw materials are extruded by screw thrusters. If there is a problem with the screw thruster, the whole process will be very slow, or the rod will not form. The section surface of the screw propeller is not less than 4mm, and the section surface is small, so the contact surface will be rough, which leads to the unsatisfactory rod output effect. Once these problems arise, it is necessary to repair the screw thruster.

2, forming barrel: raw material is extruded by screw thruster, and only in the forming tube can it form a stick. The temperature of the tube must be maintained at 260 to 300 degrees, and it can form rods. It is good to change the molding barrel in eight months, so that the quality of the staff can be guaranteed.

3. The heating ring of the rod making machine is also very important. There are three heating rings outside the forming cylinder of the bar making machine. It can raise the temperature of the forming barrel to about 350 degrees Celsius. The whole process of burning charcoal is related to heat. If the heat is too low, the rods will break and the heat will be too high. The power of three groups of heating coils is 6 kilowatt, the longer the service life is, the less the speed and efficiency is insufficient.